Thin Guitar Sides for Bending The Ultimate Guide

I start at the waist, then do the upper bout, then the lower. It takes constant small adjustments but with patience it can be made to follow the ... ... | Norman's Rare Guitars. Normans Rare Guitars•35K views · 10:48. Go to channel · How Thin Should Guitar Sides Be? DIY Guitar Making•18K views. I spent an afternoon playing with my 'bending iron'. I tried some thin spruce, and it didn't really want to play, but the offcuts of rosewood bent beautifully. Torres made sides as thin as 1 mm on occasion - way too scary for me, but I've never gone thicker than 2 mm on classical sides, which is my standard. At 2 mm, ... I think thicknessing down to 2 mm as a nominal target thickness has been established primarilly to enable the ribs to be adequately bent, thick ... I have taken mine all down to between .080 and .085" on all the woods I've bent, some by hand and some in my bender machine. This has worked out fine. Just make sure you get the wood to the proper thickness (0.075 inches, in my case) and it'll bend just fine. I did this in my home office using ... cap10kirk said: I did when I used thin picks (.73 mm Tortex), then I started using thicker picks that didn't require a death grip to hold onto ... As with the back, the top should be thinned to about 70-80thou/ 2mm thick. Choose a good side, clean it up, and mark it. Trace the ukulele shape ... In this video I show how I make the side bending jig for building a classical guitar. I used 17.5mm plywood, overall template width is 154mm ...