Ultimate Guide Achieving Perfect Guitar Bending with Optimal Side Thickness

.080" is about right for a finished guitar. I'd try and get them to .075" to .080". It would be easier ... Letting the wood heat up before trying to bend it. · Bending the wood by “rolling” it around the pipe. · Holding the bend in place after taking it off the iron. Luthiers rejoice, there's an inexpensive press that will do the job quite nicely. Luthier and woodworker Behrad Gorgani collaborated with Ted ... My sides and binding are always around 0.080". For the cutaway of my next gypsy guitar I go on the cutaway to .060". Yeahh. FWIW. Herman. Here is a short video for how I do this. Note that the thickness of the sides really matters. My usual target is .085 inches. But I will go lower with harder ... The only caveats I found were that it loosened too quickly, so you have to be careful not to over bend and tear the wood, and it can be hard to check your ... Traditionally, the sides, or "ribs" of classical guitars are bent from a solid piece of wood that is somewhere around 2 to 2.2 mm thick. You can see a couple of nasty cracks along the shoulder. They begun at the preamp cutout and because of the tension on that area of bent wood, they easily ... 120 no matter what type of wood. I see others at .125 for both. and still others at .115. To me it's quite confusing and I'm sure it is for others as well. Top thicknessing is critical to the finished sound of the instrument, and will vary depending on wood used, and how stiff that particular piece ...