Unleash Your Bending Potential Ideal Guitar Side Thickness Revealed

The sides, really for most any guitar body, should be 0.075" to 0.080" thick. For curly maple, it helps to treat with Supersoft 2 overnight to help minimize ... I used a thin kerf 7 1/4" (185 mm) blade, so as to waste less material, and to be easier on my saw. I cut from both sides to resaw a thin strip. Here is a short video for how I do this. Note that the thickness of the sides really matters. My usual target is .085 inches. But I will go lower with harder ... If you go slow and take your time everything will work out. Many people ask: How do you bend wood? Even without the steam box the answer is that ... I think you should be able to go quite a bit thinner than that. On my big Guitars I go as thin as 1.6 mm. Knock at least 0.5 mm off. You ... Guitar sides are usually extremely thin to allow stiff veneer to bend. Those thin sides have to be supported and reinforced so that it doesn't collapse in ... How to make a bending iron to bend acoustic guitar sides. Of course, it can be used to bend any kind of wood. Woodworking. That sounds good to me for a flamenco guitar. Mine are about 2.5 mm in the center and 2.0 at the edges. Once it's glued to the sides, the edges ... (Building a Guitar Step 7) Marshall will show how to bend sides for a guitar with only a pipe and a blow torch. Watch till the end to get ... The sides of a guitar are only 2mm (0.08") thick and will therefore bend much more easily than thicker wood. The simplest bending device that could be used ...