Thinner Sides, Bigger Bends A Guitarist's Guide

.080" is about right for a finished guitar. I'd try and get them to .075" to .080". It would be easier ... I thin sides to at least 0.085" (well, 2.0 to 2.2mm, really), thinner for tighter bends (down to .070 or so). Thicker also means quite a bit of ... I start at the waist, then do the upper bout, then the lower. It takes constant small adjustments but with patience it can be made to follow the ... I bend sides on a hot pipe. For guitars I bought a 6" long piece of 3" diameter pipe and put a bolt and two nuts in one side. I mount the bolt ... 10:48 · Go to channel · How Thin Should Guitar Sides Be? DIY Guitar Making•19K views · 22:00 · Go to channel · Saving Abandoned Tractor: Will It ... This is the beginning step for this build. I've chosen the set of Brazilian Rosewood that everyone seemed to love so its time to bend the sides. Here you can ... The sides of a guitar are only 2mm (0.08") thick and will therefore bend much more easily than thicker wood. The simplest bending device that could be used ... Backs between 0.085"-0.120", sides 0.70-0.085". Depends on the type of wood and size of the instrument. Some luthiers do go thinner but they are ... A guitar side bender. Both the inner and outer layer of one side are bent at the same time in the bender. Maple guitar sides taped to a solid ... Yes it is, and it's awfully low. They even say that you need a light touch to get away with it. I can't use action that low because with the ...