Guitar Bending Nirvana The Perfect Side Thickness for Seamless Bends

All of the wood for this guitar will be cut from the same billet, except the soundboard and bridge. ... The thin sides are bent over a home-made bending iron, a ... . The manufacturer claims "We have heard of good results from luthiers who use the softener to make some species of thin lumber more bendable.". I would say that .080" to .085" would be a general average. Some wood may go down to about .065" to .070" again depending. My sides and binding are always around 0.080". For the cutaway of my next gypsy guitar I go on the cutaway to .060". Yeahh. FWIW. Herman. How Thin Should Guitar Sides Be? DIY Guitar Making•19K views · 12:27 ... Bending Acoustic Guitar Sides | Using my Homemade Side Bender. Most woods do bend well at the 275 375 range. The only woods that I found to scorch at low temps was lace wood. So 1/4" or so thick is fine in a Cbg. Acoustic guitar sides have to be bent so start out thinner, I stiffen mine up after. Your top and back ... I start at the waist, then do the upper bout, then the lower. It takes constant small adjustments but with patience it can be made to follow the ... Guitar sides are usually extremely thin to allow stiff veneer to bend. Those thin sides have to be supported and reinforced so that it doesn't collapse in ... The sides of a guitar are only 2mm (0.08") thick and will therefore bend much more easily than thicker wood. The simplest bending device that could be used ...