Guitar Bending Mastery The Role of Side Thickness

Torres made sides as thin as 1 mm on occasion - way too scary for me, but I've never gone thicker than 2 mm on classical sides, which is my standard. At 2 mm, ... But the flatter radius is not what makes the guitar easier to bend on. The flatter radius is meant to stop “fret out”. This is where a string ... Just make sure you get the wood to the proper thickness (0.075 inches, in my case) and it'll bend just fine. I did this in my home office using ... Bent side, full or semi-hollow, thin-line love thread; NO SLABS. Thread Tools. 03-18-2024, ... ... thin as possible and then preparation for bending begins. ... bending something that should really shatter into pieces when bent…into a guitar. The only caveats I found were that it loosened too quickly, so you have to be careful not to over bend and tear the wood, and it can be hard to check your ... - Stock at NO THICKER THAN 3mm. Some woods crack much more readily than others; I've done red oak, mahogany, unfigured maple, and flamed maple; ... So 1/4" or so thick is fine in a Cbg. Acoustic guitar sides have to be bent so start out thinner, I stiffen mine up after. Your top and back ... Most woods do bend well at the 275 375 range. The only woods that I found to scorch at low temps was lace wood. A guitar side bender. Both the inner and outer layer of one side are bent at the same time in the bender. Maple guitar sides taped to a solid ...