Master the Art of Guitar Bending Discover the Thin Side Secret

So 1/4" or so thick is fine in a Cbg. Acoustic guitar sides have to be bent so start out thinner, I stiffen mine up after. Your top and back ... It's critical that the end that attaches to the soundboard be perpendicular to the face that's going to be glued to the sides at the butt of the guitar. I use ... Happy Building , Jason D Sides 1rst Algonquin Guitars. May be ... I can lay that thin blade right on top of the pencil marks, and make ... Before bending them, Kinkead, in his book, "Build Your Own Acoustic Guitar", recommends taking them down to 5/64" or just a little over .08 inches thick. I was ... I was nevertheless nervous before bending these sides, as a guitar side is more complicated than a mandolin. ... The next steps will be to bend ... Other builders will have their own take on this process, but this works for me. My ukes sides are normally thinned and finish sanded to about 1.7-1.8mm thick. I ... Your thickness is OK, maybe a bit thin, I like to bend sides at 0.070 to 0.085 inches. When I am bending on a hot pipe I don't know the ... I would say that .080" to .085" would be a general average. Some wood may go down to about .065" to .070" again depending. A guitar side bender. Both the inner and outer layer of one side are bent at the same time in the bender. Maple guitar sides taped to a solid ... The purfling is also attractively simple: just a thin line of green framing the back, top, sides and all inlays. ... While I will build him ...