Unleash Your Inner Bender The Ultimate Guide to Guitar Side Thickness

The specific measurement depends on how the wood is thicknessing and bending. I have used .06 for maple mandolin sides, so .065 is a good ... ... Everyday DIY•4.9K views · 10:48. Go to channel · How Thin Should Guitar Sides Be? DIY Guitar Making•18K views · 14:07. Go to channel · Steel- ... I bend sides on a hot pipe. For guitars I bought a 6" long piece of 3" diameter pipe and put a bolt and two nuts in one side. I mount the bolt ... The only caveats I found were that it loosened too quickly, so you have to be careful not to over bend and tear the wood, and it can be hard to check your ... I thin sides to 2.2 mm. For tight cutaways, I'll thin the tightest parts of the bend to less, depending upon how tight the bend is. I've gone as ... I have taken mine all down to between .080 and .085" on all the woods I've bent, some by hand and some in my bender machine. This has worked out fine. Letting the wood heat up before trying to bend it. · Bending the wood by “rolling” it around the pipe. · Holding the bend in place after taking it off the iron. How Thin Should Guitar Sides Be? DIY Guitar Making•18K views · 14:07 ... Steel-string acoustic guitar sides could break or crack with over bending. In this episode of DIY Guitar Making, I am preparing sides for the spring Guitar Build Workshops that coming up soon. Other builders will have their own take on this process, but this works for me. My ukes sides are normally thinned and finish sanded to about 1.7-1.8mm thick. I ...